[Danger Dude]

I finally installed my Bullitt pedals yesterday. They look marvelous!!!

However I will slam ford for a minute. When taken the dead pedal out to change it (It has been loose for a while) well when I go to take it out it is held by sheet metal screw. Damn Ford for not threading this, now I have to go back in a do some repairs to worn out holes to make the pedal solid again

:evil:

 

[Rellik]

sweet get pics.

 

[01mineralgrey6]

Cool!! 8) I just got mine the other day, going to go install them in a few mins.

 

[01mineralgrey6]

Any tricks to getting the brake pedal on??? I can't get the whole peice to slide over.

 

[01mineralgrey6]

Also I can't get that pin for the gas pedal to move....but i did get the dead pedal on

 

[Danger Dude]

you need to get some needle nose pliers or dikes and get them under the head of the pin and pry it loose. It was a PITA !!!! Putting it back in I used some channel locks to squeeze it back in.!!!!

 

[01mineralgrey6]

I got it all on. What a PITA , They look great!! Thanks Corey!!

 

[Danger Dude]

Cool No problem That is what I am here for

 

[Dom]

Took me a month to get that gas pedal on. One day I finnaly used a hammer and a bench vise. :twisted: