Mustang Evolution Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
434 Posts
Discussion Starter · #2 ·
It's close to touching the rear bumper but it's oerfectly straight and far enough away from potentially melting anything right now
 

·
Registered
Joined
·
2,163 Posts
No worries, you shouldn't have any issues with exhaust fitment. Have you looked into caster/camber plates and new struts/shocks for a better alignment and handling, too? These are good "required" upgrades to do while you're having the springs installed. Shoot me a PM if you're unsure what you need or have any questions!

Shane
 

·
Premium Member
Joined
·
25,510 Posts
if its a custom kit it depends on how it bends up and over the axle, it may bump it (my old 01 v6 did slightly) so just check on that and see if you have enough room.
 

·
Registered
Joined
·
357 Posts
You'll be fine I've scrapped my exhaust once and the dip was insane so you'll be fine. Plus you don't need camber plates for those either
 

·
Registered
Joined
·
357 Posts
You'll be fine I've scrapped my exhaust once and the dip was insane so you'll be fine. Plus you don't need camber plates for those either
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top