Mustang Evolution Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter · #1 · (Edited)
Installing new lowering springs up front. I just got done with passenger side. What a pain in the a$$ (with hand tools). will be going to friends house for an impact gun later today. Did anyone else have the same problem with the top part (strut mount bearing) coming apart? Does that need to be replaced or will it be okay?
 

Attachments

·
Registered
Joined
·
3,547 Posts
It just pops back together. Mine came apart too on the one side. Just make sure you didn't loose any of the bearings and don't get any gunk in there besides the grease that won't allow it too rotate smoothly.
 

·
Registered
Joined
·
73 Posts
Discussion Starter · #3 ·
Ten4 bro, that's what i was hoping to hear. I cleaned the ones that feel to the ground and placed them back into position. It did rotate smoothly when i reassembled it. Thank you sir.
 

·
Registered
Joined
·
3,547 Posts
Ten4 bro, that's what i was hoping to hear. I cleaned the ones that feel to the ground and placed them back into position. It did rotate smoothly when i reassembled it. Thank you sir.
Yep then you are good too go. No worries :)
 
1 - 4 of 4 Posts
Top