Mustang Evolution Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,065 Posts
Discussion Starter #1
Now $75 + shipping, was 100, and I'll include a few
cartridge rolls (and a mandrel) and flapwheels.
Most shipping will be $10 to USA. NEW speed
control, and rarely used die grinder, very little use
on either one. I'll include a few carbides, $5 each!

THIS IS A GREAT DEAL!!!

Includes wrenches, rarely used, I have air tools and don't need this.



That's a quarter on there for size
reference, it's a good sized but light
grinder, reduces fatigue while grinding.

I still have the receipt for the speed control, it's a Dremel
6 Amp unit, will handle any hand-held electric die grinder
I have ever seen. Good low-speed torque too, it's a nice one!
 

·
Registered
Joined
·
567 Posts
Tire said:
i am quite sure it is, but i want to make 100% sure that this is the best tool for p/p intakes/heads. your honest opinion?
not to bag on RGR's sale, but an air grinder would be the "best"

But I'm sure this will get the job done rather well.
 

·
Premium Member
Joined
·
5,187 Posts
OMG you bagged Robert :no: :no: :no: You should be ashamed you you bagger you !!!! :rolleyes: :rolleyes: :rolleyes: :rolleyes: :| :|

BROTHER COREY MIGHT NEED TO VISIT YOU!!!!!!
 

·
Registered
Joined
·
1,065 Posts
Discussion Starter #7
actually, he's right! but for 1 set of heads/intakes
this is much cheaper. Air tools are not that bad, it's the
compressor costs that kill you.
This is best for 1 or 2 jobs.
 
1 - 7 of 7 Posts
Top