Mustang Evolution Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I have a 95 gt mustang I bought a used motor for and the motor was on a auto tranny it had the old flywheel and bellhousing spacer well I changed the flywheel and put the clutch and pilot bearing in but I thought I could use the same spacer but It woulnt cover the bottom o the flywheel should I buy a new one or is there any way I could use the old one and just buy a adapter to bolt to the bottom open section??? Any help would be great thank u!!!!
 
1 - 3 of 3 Posts
Top