Mustang Evolution Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
I have a 1994 Mustang with a 3.8 Litre Engine and Manual 5 spd Tranny.

While trying to replace a bad clutch, I broke the bolt and stud for the starter. One is a bolt, the other is a stud with a nut, but have 13 mm head/nut and both of course screw into the bell housing.

I have contacted a ford dealership directly and they don't have the info!!!!!! Weird! (so don't leave an answer saying "contact ford"!

My question is simple, I either need a part number for each (one for bolt, one for stud and nut), or the sizes if I were to go to a hardware store.

Please be precise size, length, head, etc, and again, don't just leave an answer saying see ford, or take the old one in! can't do that, they broke and had to destroy the nut to get them out of the bell housing.

Thanks in advance.

Jay
 

·
Registered
Joined
·
38 Posts
Go to your local junk yard or get the CHILTON manual from Auto Zone or Checker parts. Thius will tell you what you need.
 
1 - 2 of 2 Posts
Top