Mustang Evolution Forum banner
1 - 17 of 17 Posts

· Registered
Joined
·
455 Posts
Discussion Starter · #7 ·
Looks nice. Did you put a clear on it or leave it matter black? It's hard to tell on my phone.

---------- Post added at 07:02 PM ---------- Previous post was at 06:58 PM ----------

Nevermind I blew the pic up. Looks really good. You did a good job. I hope mine comes out that straight. Any advise before I do it?
 

· Registered
Joined
·
5,268 Posts
Looks nice. Did you put a clear on it or leave it matter black? It's hard to tell on my phone.

---------- Post added at 07:02 PM ---------- Previous post was at 06:58 PM ----------

Nevermind I blew the pic up. Looks really good. You did a good job. I hope mine comes out that straight. Any advise before I do it?
just cover up ur bumper real good and rear fenders. tape up the top of decklid the most str8 possible. and spray the first coat like 6in. away so it wont have any runs. after u give it one coat give it a few minutes or so , that way it can dry up. then give it another coat. u should be good with 2 or 3 coats at most. then when u remove the tape be very careful and use a blade or knife if u need to cuz the plasti dip tends to stick on the tape and can come out crooked.
 

· Registered
Joined
·
455 Posts
Discussion Starter · #12 ·
Horseplay said:
just cover up ur bumper real good and rear fenders. tape up the top of decklid the most str8 possible. and spray the first coat like 6in. away so it wont have any runs. after u give it one coat give it a few minutes or so , that way it can dry up. then give it another coat. u should be good with 2 or 3 coats at most. then when u remove the tape be very careful and use a blade or knife if u need to cuz the plasti dip tends to stick on the tape and can come out crooked.
Thank you much. I'll post pics when I get it done. Oh, one more thing. Did you do any prep work before so it will stick better?
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top