Mustang Evolution Forum banner

1 - 17 of 17 Posts

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #1
i just bought a ported intake from suprman and im wondering if theres anything that i have to besides take my old one off and put the new one on. Is that all i have to do or do i need to replace anything else?
 

·
Registered
Joined
·
1,286 Posts
if the gaskets are bad, then put new ones on. other than that, just swap them out and bolt everything back up. double then triple check you have vacuum hoses on, cause most of the time, you forget one
 

·
Premium Member
Joined
·
5,187 Posts
Yes like Brandon said check the vac hookups. You have a 95 if he has a 97-98 intake there will be more vacume line hookups you will need to cap. Other than that it is remove and replace. I went the other way My stage 3 is a 94-95 and had less hookups than my 98 had.
 

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #4
i believe the one i bought was for a 95 as well so im hoping i dont have any extra hookups... we'll see
 

·
Registered
Joined
·
1,065 Posts
IMO you need at least a 1/2 shafted TB or a bigger TB to
take advantage of a ported intake. 1/2 shafted and ported,
a stocker will flow LOTS more than stock, so it is worth it.
 

·
Registered
Joined
·
567 Posts
RGR said:
IMO you need at least a 1/2 shafted TB or a bigger TB to
take advantage of a ported intake. 1/2 shafted and ported,
a stocker will flow LOTS more than stock, so it is worth it.
my next mod after a tune ^

:D
 

·
Registered
Joined
·
1,552 Posts
Better off to change tbodies before tuning if you are going to do a tune, changing after will only mess up your tune.
 

·
Registered
Joined
·
567 Posts
Rick0636 said:
Better off to change tbodies before tuning if you are going to do a tune, changing after will only mess up your tune.
the car would adapt enough for a small change like porting out a TB.

I have enough problems and the tune is necessary.
 

·
Registered
Joined
·
1,552 Posts
ok then :p
 

·
Registered
Joined
·
1,065 Posts
I agree with rick in most situations, but if $$ are low, then it would be OK.
 

·
Registered
Joined
·
1,065 Posts
you might wanna check out my new Poly-Hone process...

I can finish off your intakes in grand style :D
Honed as a single unit 8) Since they are already
ported, it would be cheaper!
 

·
Registered
Joined
·
155 Posts
yeah you should be allright, but i would check the gasket! if you need a vac cap, i think i have some lying around here that i could send you one, also i think i'll have my TB that was half-shafted and ported by RGR up for sale soon as i'm going with a 60mm GT TB!

i think if you had it polyhoned it would be awesome as well! i'm thinking of getting my stage 3 intakes done!
 

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #16
suprman, is this an intake from a 94-95 or am i going to need some vac caps?
 
1 - 17 of 17 Posts
Top