Mustang Evolution Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
686 Posts
Discussion Starter · #1 ·
I have the car lifted, and i looked underneath, what am i unbolting on the tranny? Its a 98 gt. do i need to drop the k member? Thanks!
 

·
Registered
Joined
·
6 Posts
If you're working on a lift you can drop the k-member with the motor and trans together. Then roll it out from underneath. If not you can disassemble the trans from the engine, pull the bell housing then lift the motor out.
 

·
Registered
Joined
·
686 Posts
Discussion Starter · #3 ·
Is it easier to pull it from the bottom? I have a electric engine hoist and everything.. I'd rather not pull the tranny ya know? Just an engine rebuild
 

·
Registered
Joined
·
3,858 Posts
Rebuild? What's your plans?
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top