[813floridaracin]

I'm in the process of making a fiberglass back seat but I can't figure out how to take off the portion where our backs go. I got the bottom seat out.. And help would be greatly appreciated

 

[Project Pony]

Fold both sides down. There should be 3-4 bolts that go across the top, and 1-2 on the bottom.

 

[813floridaracin]

The 3-4 on the top. Are those for the metal prongs that the seats clip onto? And on the bottom there is a metal pipe that runs through the entire width of the seat attached to the bolt. I'm assuming I unscrew the bolt and slide the seat off the pipe?

 

[813floridaracin]

Just going to bump this back on the current thread page. Can anyone else help?

 

[kickerofdoom]

Should be some bolts there

 

[Project Pony]

I think there were 4-5 bolts, 10mm. That bottom "pipe" if I remember correctly is attatched to the seat frame. The bolt with be further down that that.

 

[813floridaracin]

I think there were 4-5 bolts, 10mm. That bottom "pipe" if I remember correctly is attatched to the seat frame. The bolt with be further down that that.

Alrigh thanks man,I'm going to give it another look once it warms up

 

[Sluder4]

When I took mine out there were six folding everything in you'll need some decen torque to get them out