Mustang Evolution Forum banner
1 - 14 of 14 Posts

·
Registered
Joined
·
3,460 Posts
Discussion Starter · #1 ·
Anyone got one? I was looking at cj pony and they have one that says Shelby on it for 99. Steeda is for 189 and adjustable. I want one front and back. So which one is better? Getting a boss 302 front btw
 

·
Registered
Joined
·
146 Posts
Yep,I bought one from them and have it installed.
It only sits up about 1" off the floor.

I don't really know if it helps but when I do get a
little tire spin the rear of the car stays pretty straight.

Install took about 10 minutes.
 

·
Registered
Joined
·
3,460 Posts
Discussion Starter · #9 ·
My subs are there lol
My sub doesn't fit there. It has to sit on a flat piece and on the driver side. Not the best, but its a custom box from my 02. Just too cheap lol

---------- Post added at 11:43 PM ---------- Previous post was at 11:42 PM ----------

Yep,I bought one from them and have it installed.
It only sits up about 1" off the floor.

I don't really know if it helps but when I do get a
little tire spin the rear of the car stays pretty straight.

Install took about 10 minutes.
Is yours steeda? I really want the Shelby one cause its just 99. Btw are the bolts and stuff in mustangs standard or metric?
 

·
Registered
Joined
·
607 Posts
My sub doesn't fit there. It has to sit on a flat piece and on the driver side. Not the best, but its a custom box from my 02. Just too cheap lol

---------- Post added at 11:43 PM ---------- Previous post was at 11:42 PM ----------



Is yours steeda? I really want the Shelby one cause its just 99. Btw are the bolts and stuff in mustangs standard or metric?
Most modern cars use metric and torx bolts
 

·
Registered
Joined
·
146 Posts
The install is very easy.Just in order to remove and put the
shock nuts back on you have to use a wrench to hold
the very top of the shock bolt so it wont spin.

You will need two people,one to hold a wrench on the top
shock bolt and one to tighten the shock nut.
 
1 - 14 of 14 Posts
Top