Mustang Evolution Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
Where is the receiver for the signal from the key fob? I am trying to find the wire that arms the anti-theft system upon locking. I am making my engine immobilizer tie in with it, and I need the wire to arm the immobilizer too. ANy ideas?

The wiring diagram I was looking at says that the factory alarm arms upon locking, but if I wire it to the power locks, I am afraid that if someone were to hit the lock button while I am driving it would disengage the engine.
 

·
Registered
Joined
·
2,356 Posts
You might have to break out a Ford wiring diagram. I doubt that information would be in a Haynes maunual. I'm assuming the remote start was Ford aftermarket right?
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #3 ·
Actually it is not a remote starter. Just an immobilizer. It is a keypad kinda like in the transporter in his bmw. I installed it but it needs to arm itself by being wired to the pre-existing alarm. Thank you however for responding.
 

·
Premium Member
Joined
·
19,783 Posts
Hm...I'm trying to remembery what was tapped into on my car for the viper alarm...but can't remember lol.
 

·
Premium Member
Joined
·
25,803 Posts
the oem module is in the trunk on the driver side behind the trunk liner.
 
1 - 7 of 7 Posts
Top