Mustang Evolution Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
457 Posts
Discussion Starter #1
My car didn't have them, so I've got a set, and am having some trouble installing a piece held on my two screws. Yes, I feel dumb.

What kind of screws hold this thing in? They came with a torx headed screw probably over an inch long and I can't get any of them to start.

ImageUploadedByMustang Evolution1438703429.476059.jpg
ImageUploadedByMustang Evolution1438703450.643255.jpg
ImageUploadedByMustang Evolution1438703479.012780.jpg

It might help if my headrests would come up more than just a little- how far should they be able to come up?



Sent from my iPhone using Mustang Evolution
 

·
Registered
Joined
·
8,486 Posts
Those look like the correct screws.
The headrest only goes up as far as you have it, in the picture. It does however roll forward, and that may give you some extra room to work.
 

·
Registered
Joined
·
457 Posts
Discussion Starter #3
Well knowing they are the correct screws helped.

I bought a small pick set and managed to find the holes- they weren't lined up, the leather had pulled forward.

It was a gigantic pain but I got them installed ??


Sent from my iPhone using Mustang Evolution
 

·
Super Moderator
Joined
·
17,969 Posts
Well I'm glad you finally found the hole. It can be a pain for first timers...














:)
 

·
Registered
Joined
·
457 Posts
Discussion Starter #5
?????


Sent from my iPhone using Mustang Evolution
 
1 - 5 of 5 Posts
Top