Mustang Evolution Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
861 Posts
Discussion Starter #1 (Edited)
I was in the process of removing seatbelts for repair and discovered a necessity for a torx socket. What's the size and type of bit/socket do I need? On a side note if anyone ever needs to take the rear seats out of they're foxbody convertible, be aware the two bolts holding the upper seat back in are at the bottom corners behind the cushion, you can't really pull it back without locking the bolt and ford engineers decided the bolts you can't see, can barely feel should be 10mm...

88 convertible
 

·
Registered
Joined
·
861 Posts
Discussion Starter #3
Yeah 10mm for the lower two bolts on the seat BACk and its like t50 or t55 for the size of the seatbelt to chasis bolts.
 
1 - 4 of 4 Posts
Top