Mustang Evolution Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter #1
I am hooking a single 10" sub up to my factory shaker 500 system, and I am going to use a line level converter, because I don't need to spend half a grand on a new head unit right now. What I need to know is which wires do I splice into by the factory amps? Which ones are + ? Which are -? Pictures would be great if somebody has them.
 

·
Registered
Joined
·
545 Posts
Sorry to dig up and old thread but I have 2 questions:

1. what do the "infinity" symbols around the speaker wires mean?

2. Is this diagram representative of the 2013 Shaker system in my premium coupe. I don't have the shaker pro.
 

·
Registered
Joined
·
125 Posts
I am hooking a single 10" sub up to my factory shaker 500 system, and I am going to use a line level converter, because I don't need to spend half a grand on a new head unit right now. What I need to know is which wires do I splice into by the factory amps? Which ones are + ? Which are -? Pictures would be great if somebody has them.
so did this work? and was the amp good enough to run it all?
 
1 - 8 of 8 Posts
Top