Mustang Evolution Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I have a squeekin problem in my 98 v6 3.8l an it happends when you turn it on an then its stays squreking for a while longer then it graudualy goes away
 

·
Registered
Joined
·
811 Posts
this sounds a lot like the problem i have recently had. if it is it would be your crank angle sensor and camshaft position sensor. the crank angle sensor and camshaft position sensor are located under your coil pack assuming there arent any differences in our cars which i dont believe there would be. the sensor assembly goes in place of where there would be a distributor if it were an older car.

---------- Post added at 09:42 PM ---------- Previous post was at 09:40 PM ----------

So you did change the belt? Could be the release bearing for the clutch. If you can push or release the clutch and affect the noise that will help you realize that it is the problem
if it were the tob or clutch the sound most likely wouldnt go away. atleast not from what ive experienced anyways.
 
1 - 8 of 8 Posts
Top