Mustang Evolution Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
So I am rebuilding my new motor and when I was cleaning up the new block a bunch of debris got into the cylinders on top of the pistons. I'm not sure how to get all of it out because I know this will not be good to start it with that in there . Any good tricks u engine assemblers know about. Lol. I don't want to **** it up right when I start it lol
 

·
Registered
Joined
·
80 Posts
Compressed air and blow it out

---------- Post added at 04:04 PM ---------- Previous post was at 04:03 PM ----------

Thats what I usually do after cleaning the head surfaces on the block
 
1 - 2 of 2 Posts
Top