Mustang Evolution Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
101 Posts
Discussion Starter · #1 · (Edited by Moderator)
I just installed new sway bar end-links on my 2002 GT. Do I need to tighten them more, or do these look sufficiently tight? I used my Milwaukee cordless impact gun to tighten them, so I don't know what exact torque they're tightened down to. I just didn't want to go too tight, but part of the bushing directly under the sway bar isn't contacting the bar. Do they look like they need to be tightened more? Is there a torque spec? Thanks.


Motor vehicle Automotive tire Bicycle part Vehicle Rim
Bicycle part Carbon Material property Rim Gas
Automotive fuel system Automotive tire Motor vehicle Automotive exterior Coil
 

·
Registered
Joined
·
563 Posts
I think both bushings should be in contact and partly compressed or you’ll have noise.


Sent from my iPhone using Tapatalk Pro
 
  • Like
Reactions: dmw_4814

·
Administrator
Joined
·
9,775 Posts
Moved to Suspension Forum
 
1 - 4 of 4 Posts
Top