Mustang Evolution Forum banner

1 - 3 of 3 Posts

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #1
when i changed my springs on the front i had to unbolt the front swaybar to allow my A-arm to fall enough, and when i tightened it back up, i noticed it didnt really get "tight" cause of the bushings on there. Is that a sort of adjustable sway bar up front? How tight should I tighten that down and what difference will it make if its looser or tighter?
 

·
Registered
Joined
·
414 Posts
With the springs dropping it about an inch, the sway bar won't be in the stock position. You can get shorter endlinks to correct that but you don't NEED them. At least, I think this is what you are talking about.
 

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #3
im talkin about the 2 bushings thats the sway bar sits on that is in the front wheel wells. They dont just tighten up to a specific point, they could be loose, or i could mash the bushings and itd be really tight... get what im sayin sorta? When i do my front struts ill take a picture of what im talkin about to clarify it a bit more.
 
1 - 3 of 3 Posts
Top