Mustang Evolution Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
172 Posts
Discussion Starter · #1 ·
Guess I should have bought a precut one, but was afraid my hood pin brackets may not line up.

Hood pins are already installed I'm just replacing the rad cover that was cut but previous owner.

Looking for tips on cutting/drilling? It's a Shelby hood pin set.

Any pictures would be good too.
Thanks guys
 

·
Registered
Joined
·
1,890 Posts
Guess I should have bought a precut one, but was afraid my hood pin brackets may not line up.

Hood pins are already installed I'm just replacing the rad cover that was cut but previous owner.

Looking for tips on cutting/drilling? It's a Shelby hood pin set.

Any pictures would be good too.
Thanks guys
Go to American muscle website. They sell those and I think they have a step by step install sheet.
 

·
Registered
Joined
·
1,890 Posts
Ya they do but that step says "cut holes in rad cover and reinstall"
I'd use a dremel to cut the rad cover since its plastic. I just installed some on my sons 67, no rad cover of course. I used a small drill bit to start and then went up to a step drill. You have to be real careful with regular drill bits, the thin sheet metal grabs the bit.
I guess I'm not really sure what your question is.
 

·
Registered
Joined
·
158 Posts
Partscheap.com or any ford dealer can sell you a Pre cut shelby rad cover cut for hood pins.
 
1 - 5 of 5 Posts
Top