Mustang Evolution Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
Has anyone installed these and was the power gain noticeable?
Cmcv delete plates? Same question as above. Worth the effort or no noticeable gains?
 

·
Registered
Joined
·
1,699 Posts
They are dyno proven to give gains. Both are. Both installed at the same time may be noticeable. Otherwise, individually may not be.

They are just mods you throw at the car near the end when you want every bit of power. They are both easy to install, even for beginners.
 

·
Registered
Joined
·
2,789 Posts
With them both you should expect 15hp 15tq give or take a bit depending on your other mods
 

·
Registered
Joined
·
30 Posts
Discussion Starter · #5 ·
They are the one inch thick plate on top of your manifold that have valves over all 8 intakes. One plate pet side. A Delete plate is a version of the cmcv plates minus the valves. No airflow restriction. The valves usually begin to open at 3000rpm's. Without them your wide open. Gas mileage probably drops a bit. Only 2005-2008 need them. 2009 they stopped putting the cmcv plates in. And it came stock with deletes. That's why I think everyone thinks they need em. If ford changed them,must be better. It does require a tune and plates and tune will run you 300$-$500. Is 8hp worth it?
 

·
Registered
Joined
·
193 Posts
They are the one inch thick plate on top of your manifold that have valves over all 8 intakes. One plate pet side. A Delete plate is a version of the cmcv plates minus the valves. No airflow restriction. The valves usually begin to open at 3000rpm's. Without them your wide open. Gas mileage probably drops a bit. Only 2005-2008 need them. 2009 they stopped putting the cmcv plates in. And it came stock with deletes. That's why I think everyone thinks they need em. If ford changed them,must be better. It does require a tune and plates and tune will run you 300$-$500. Is 8hp worth it?
Glad my Gt is an 09
 

·
Registered
Joined
·
1,699 Posts
They are the one inch thick plate on top of your manifold that have valves over all 8 intakes. One plate pet side. A Delete plate is a version of the cmcv plates minus the valves. No airflow restriction. The valves usually begin to open at 3000rpm's. Without them your wide open. Gas mileage probably drops a bit. Only 2005-2008 need them. 2009 they stopped putting the cmcv plates in. And it came stock with deletes. That's why I think everyone thinks they need em. If ford changed them,must be better. It does require a tune and plates and tune will run you 300$-$500. Is 8hp worth it?
It's worth it if you're at the end of modding goals and need every last bit. 8 hp across the board usually
 

·
Registered
Joined
·
2,789 Posts
They are the one inch thick plate on top of your manifold that have valves over all 8 intakes. One plate pet side. A Delete plate is a version of the cmcv plates minus the valves. No airflow restriction. The valves usually begin to open at 3000rpm's. Without them your wide open. Gas mileage probably drops a bit. Only 2005-2008 need them. 2009 they stopped putting the cmcv plates in. And it came stock with deletes. That's why I think everyone thinks they need em. If ford changed them,must be better. It does require a tune and plates and tune will run you 300$-$500. Is 8hp worth it?
Lol the 09-10s are molded into the intake not deleted lol

---------- Post added at 01:48 PM ---------- Previous post was at 01:45 PM ----------

Glad my Gt is an 09
I love the poor information on the forums, but here you can use these on your 2009 sir

http://www.steeda.com/store/ford-mustang-charge-motion-delete-plugs-for-ford-mustang.html
 

·
Registered
Joined
·
30 Posts
Discussion Starter · #9 ·

·
Registered
Joined
·
1,699 Posts
If you notice,I asked the initial question. Sorry for poor info however it was relayed to me from Robinson Brothers Ford in Baton Rougge La.
With all due respect to real and knowledgeable mechanics out there, most dealers have Mechanics who work at Ford. Not Ford mechanics. Their opinions are usually personal and misinformed. They're great for fixing an OEM product to OEM spec.
 

·
Registered
Joined
·
30 Posts
Discussion Starter · #11 ·
That's why I'm here asking questions. Just seems everyone is more knowledgable about car colors and 22" rims yo..lol.
 

·
Registered
Joined
·
1,699 Posts
That's why I'm here asking questions. Just seems everyone is more knowledgable about car colors and 22" rims yo..lol.
Tell me about it. Not even a joke. There are some regulars with years and years of valuable experience.
 
1 - 12 of 12 Posts
Top