Mustang Evolution Forum banner
1 - 7 of 7 Posts

· Premium Member
Joined
·
36,639 Posts
I had a fog light that got water in it a while back. Take the head light out and take it inside drain the water out as good as you can and then use a long pencil or something with some sort of debri free (lint free if you can) cloth to clean all you can finish up with a hair dryer to evaporate the water thats left and go back over it and buff it clean. Thats about all i can tell you unless you cut open the head light and you might screw it up doing so. My fog light I just evaportated the water and it cleaned up good as new.
 

· Premium Member
Joined
·
36,639 Posts
yea and use a hair dryer it will evaporate the remaining mouisture just have the opening facing upward. if your lights are yellowed take this as an excuse to get new black ones or different ones or what ever you want. did you cut them open and remove the corners? if so thats probably why its getting water in.
 

· Premium Member
Joined
·
10,375 Posts
yes remove the headlight, take out the bulb, pour the water out. Take a hair drier and on hot aim towards the bulb hole and in about 10 min it will be completely dry. Go et some 100% silicone sealant and run a bead around the entire seam of the lens let dry and reinstall.
 

· Premium Member
Joined
·
5,393 Posts
Danger Dude said:
yes remove the headlight, take out the bulb, pour the water out. Take a hair drier and on hot aim towards the bulb hole and in about 10 min it will be completely dry. Go et some 100% silicone sealant and run a bead around the entire seam of the lens let dry and reinstall.
yeah thats your best bet, but is this from the water thing you had? but yeah just let them air out.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top