Mustang Evolution Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,161 Posts
Discussion Starter #1
Would an exhaust shop be able to weld up and h pipe and some high flow cats to replace the stock mid pipe but make it to where I can swap them back out if necessary? Also how much would this cost? Would it just be cheaper to buy an mrt and have it installed?
 

·
ME Bloodhound
Joined
·
14,699 Posts
They should be able to do it, but why not just just buy a catted H pipe? It is pretty much the same concept. And at that point it is just a clamp on so you should be able to swap it out whenever.
 
1 - 3 of 3 Posts
Top