Mustang Evolution Forum banner

1 - 11 of 11 Posts

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #1
I wanna put my ported upper onto my car this weekend, but what gaskets do i need to replace? I know the one that goes between my upper and lower, and then the throttle body one too, is that it? Also, part numbers would be awesome if anyone knows them :) Thanks
 

·
Premium Member
Joined
·
1,461 Posts
the one between the upper and lower is re-useable and just go to autozone and get the TB gasket. Ask for it by name, should only be a few bucks.
 

·
Premium Member
Joined
·
1,461 Posts
no, it's not suppose to be, its more of a paper gasket. You might have gotten lucky and took off your TB while the gasket was new. What year is your car? I'm assuming an 02 from your name. That would explain why you can re-use it. It hasn't been baked into place yet.
 

·
Registered
Joined
·
1,552 Posts
I don't like reusing any of those gaskets really, but I have done it. Thing is they might look ok and cause a vacuum leak and it would be real hard to find the leak.
 

·
Registered
Joined
·
574 Posts
97Stallion said:
That would explain why you can re-use it. It hasn't been baked into place yet.
That makes sense. When I took it off both sides had like a semi-sticky gray film on them. But none of it actually stuck to the intake or TB. So!
 

·
Premium Member
Joined
·
1,461 Posts
nah, i wouldn't worry, if you had problems you'd know it.
 

·
You want to **** me?
Joined
·
4,043 Posts
Discussion Starter #11
well i didnt get around to it, but next weekend maybe :) thanks guys
 
1 - 11 of 11 Posts
Top