Mustang Evolution Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I have a 1968 mustang ..i need a drive shaft ...trans is original and so is the rear end ......what size shaft do i need... its a 302 and a c4 trans....
 

·
Registered
Joined
·
2 Posts
Any machine, or driveline shop can make one, they just buy the parts and weld it up and balance it...or get one from a Mustang only salvage yard...or watch http://craigslist.org for someone parting one out..

I used a 85 Turbocoupe one and had it cut down..
 
1 - 3 of 3 Posts
Top