Mustang Evolution Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
148 Posts
Discussion Starter · #1 ·
Just ordered 1.5in spacers. Was wondering if anyone had pics of there car with 18x9 with 1.5 spacers. I want to see how it's going to look. Thanks.
 

·
Registered
Joined
·
344 Posts
I dont have pics but i had 1.5" spacers... looked flush with rear fender, not all tucked in. It just sucked when i lowered my car. A few bumps and dips from the road going into an inclined driveway.. id have to roll the fenders or take off the spacers. I noticed a few scrapes and gouges in my tires, so i took the spacers off.
 

·
Registered
Joined
·
148 Posts
Discussion Starter · #3 ·
Damn. That's what I was afraid of. Because I'm lowered 2ins. I'll see where it's sitting. I don't normally drive on ****ty roads. I'm running 245s though.
 

·
Registered
Joined
·
672 Posts
Those spacers should fill up the wheel well quite nicely. The rear quarters on the NE's are so wide that spacers are almost needed IMO
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top